View Single Post
Old Jul 20, 2004, 05:21 PM
power is offline
Find More Posts by power
Begin with end in mind...
power's Avatar
Eagle Lake, Minnesota
Joined Apr 2003
5,615 Posts
I don't know if anyone has posted anything about holding onto the stator while winding but this is my winding stand, you can get the same results from taking a 5/16-18 cap screw (a long one maybe 5 in) screw a nut on all the way and snug it up. Now go to the grinder/sander and spin the nut down enough to shoulder on the non insulated part of the stator, Take another nut and do the same thing, put the stator on the screw and snug up the nut, clamp the screw in a vise and you have a third hand. This really helps getting the windings tight

POWER
power is offline Find More Posts by power
Reply With Quote