Thread: Discussion Dynam Devil 3D
View Single Post
Old Feb 12, 2013, 10:22 AM
RCAV8T0R is offline
Find More Posts by RCAV8T0R
Feeding the RC Addiction
RCAV8T0R's Avatar
United States, CA, San Diego
Joined Apr 2011
585 Posts
Got a Bigger Hammer...

...& pounded the snot out of it......not really...

Quote:
Originally Posted by dkrhardy View Post
RCAV8T0R - did you do anything with the "cupped" elevator?

Don
Forced the trailing edges flat by CA'ing carbon fiber strips on them so that part of the "bow" is straight. I may need to do more work trying to straighten out the "cupping" using (lower) hair dryer heat as you've suggested. Right now, I've got prop balancing issues that need to get sorted out... Didd all this before with the Peaks & had some limited success. I ended up mixing out the coupling in KE flight with a R/E mix since she pulled to the gear badly......

My D-3D's gettin' there. Probably the most important change was with my TX settings, dialing down the low rates & upping the EXPO since she was too pitch sensitive with the CG set so far back. Lookin' forward to trying her out again very soon...
RCAV8T0R is offline Find More Posts by RCAV8T0R
Reply With Quote