View Single Post
Old Feb 11, 2013, 07:33 AM
Ken59 is offline
Find More Posts by Ken59
LearningFast
United States, LA, Denham Springs
Joined Jan 2012
411 Posts
Are the wire ends exposed at the motor? It has been quite a long time since I took the tail apart. If so, just check your voltage there with your meter. If not, you can actually measure the voltage at the pcb. Just pull the plug and measure at the pins. When you increase throttle, the voltage will rise and lower with throttle. Same thing with the main motor. Look back in the thread and Ribble did quite a bit of measurements on voltage on the 9104. I will look, also.
Ken59 is offline Find More Posts by Ken59
Reply With Quote