Thread: Discussion Another new 2.4GHz system!
View Single Post
Old Feb 10, 2013, 10:09 PM
77095066 is offline
Find More Posts by 77095066
Registered User
Joined Feb 2013
2 Posts
Hi , I tried this mod for one of my CT6B's and it is not working as a trainer, just to be sure you connected the end of the yellow wire going to the transmitter module to the center position of the switch, the end going to the main board to end one and the cut red wire from the trainer port (next to the black wire) onto end two of the switch?

I have scoured the thread and did not find any other discussions on this mod but it has been a very active thread sorry if it has already been addressed and I missed the update.

This is in reference to the original post #1697 where directions were given to add a momentary switch to the CT6B to allow it to be used as a master buddy box.

Has anyone had any luck with this modification, and if so can you help me understand where I might have gone wrong?

Thank You in advance for any useful advice!
77095066 is offline Find More Posts by 77095066
Last edited by 77095066; Feb 10, 2013 at 10:38 PM. Reason: I had omitted reference post
Reply With Quote