Thread: New Product Parkzone's VisionAire
View Single Post
Old Feb 10, 2013, 07:52 PM
Maddog20 is offline
Find More Posts by Maddog20
Registered User
United States, OH, Mason
Joined Nov 2011
100 Posts
I am in the process of setting up my TX and I'm having a hard time understanding this part of the manual:

DX7s and above transmitters can activate rates on one Dual Rates
switch like the DX6i transmitter. However, DX7s and above transmitters can
also activate rates and exponential on the same switch as the flight mode
(Channel 5). If desired, GF (General Flight) mode can activate low rates with
moderate exponential, and 3D mode can activate high rates with exponential
on a curve.


I have a DX7s and when reading through the first few pages of this topic Quique stated take off in General flight (Flight mode 0) and D/R's set to 1. But, if I set the daul rates to be slaved to the Flight Mode switch the Dual Rate switches do not do anything. Am I missing something? Also, what is exponential on curve and where is that setup?
Maddog20 is offline Find More Posts by Maddog20
Reply With Quote