Thread: Discussion The HK 450 story continue
View Single Post
Old Feb 10, 2013, 12:44 PM
2Doggs is offline
Find More Posts by 2Doggs
just gotta mess with it!
2Doggs's Avatar
North West Louisiana
Joined Nov 2009
6,152 Posts
Peen!

Sometimes you can tighten up the swash. If you look on the underside, you may see four or more points where it's been peened together - and using a small hammer and a suitable punch, you might be able to tighten it up if the bottom half is not pressed all the way up.

Don't use threadlock on any plastic parts, by the way, the maingear bolts hold just fine into the plastic. Sometimes you can take out some wobble by annealing the gear - soaking it in hot water for a while, though I've always just replaced the gears, and keep plenty in stock. You could try refitting the gear rotated thru 90 degrees to see if it makes any difference.
2Doggs is offline Find More Posts by 2Doggs
Reply With Quote