Originally Posted by 2500GENE
I'm a bit confused in what you just said.....you say you set everything out then every thing in on the horns. That will give you the same amount of throw either way. You want outer hole on the servo and inner hole on the control surface horn for maximum throw.
Being a 3d guy you may already know this and I just read it all wrong. If so I blame it all on Ted, he's used to it.
To clarify, I adjusted only the horns on the surfaces, the servo horns are on the longest setting now. So the adjustment I was referring to was to adjust from the outer to innermost holes at the control surface.
I'm going to have another look at his plane tomorrow. i bet a larger horn is required on both sides. Everything just seemed so small to me, but It was my first time seeing one of these designs in person no matter what mm size ws it was.