Thread: Discussion The Cube
View Single Post
Old Feb 07, 2013, 01:35 PM
corocopter is offline
Find More Posts by corocopter
Registered User
Joined May 2010
436 Posts
You can cut a tin can with a good pair of scissors, cut strips about 1/4 inch wide by 3 inches long, wrap the strip around a broom handle to set a radius in the middle, straighten out the ends. Epoxy one strip on each side of the severed vane, with the loop-side outward, this will allow for slack in the strips to facilitate the adjustment of the vanes. Before you glue the first strip on, off-set the vanes at least 25 degree.

Kelly
corocopter is offline Find More Posts by corocopter
Reply With Quote