View Single Post
Old Feb 06, 2013, 08:17 PM
wyowindworks is offline
Find More Posts by wyowindworks
Just fly it!
wyowindworks's Avatar
Cody, WY
Joined Nov 2007
6,919 Posts
For pristine parting lines I always use thicken resin to fill the gap between the plug and the parting plane. After it cures I remove the parting plane/plug and block sand the thickened resin flush with the parting board. This makes a nice sharp corner.....although the sharp corner gets rounded out if you are using PVA. If I use PVA I just use clay to fill the gap.
wyowindworks is offline Find More Posts by wyowindworks
Reply With Quote