Thread: New Product F3J Vixen
View Single Post
Old Feb 06, 2013, 09:45 AM
Cap_n_Dave is offline
Find More Posts by Cap_n_Dave
Registered User
Joined Mar 2008
649 Posts
Quote:
Originally Posted by Daryl Perkins View Post
If I ever would need to get the servo out, I can heat up the coupler with a soldering iron, slide it off the spline, and pop the servo out. Notice I don't use much 5 minute.
Not sure if you could make this stuff work, but "electrically disbonding eopxy" seems to good to pass up ... it could potentially make one's life easier ...

http://www.eiclabs.com/ERhome.htm
Cap_n_Dave is offline Find More Posts by Cap_n_Dave
Reply With Quote