Thread: Discussion micro t - brushless setup!!!!
View Single Post
Old Feb 05, 2013, 09:15 PM
shahram72 is offline
Find More Posts by shahram72
Registered User
United States, SC, Irmo
Joined Sep 2011
4,993 Posts
OK I solved the steering servo issue. No servo saver with this setup but not sure there is enough force on this little car to break anything and if it does so what, it's a $3 servo. This was quick and it works.

Losi Micro Desert Truck with HXT500 steering servo (0 min 21 sec)


I took the mounting tabs off with the dremel and then used the T servo arm included with the servo and lopped off 3 arms leaving one of the short ones off. Trim it well with a knife. Use one of the mounting screws (included with the servo through the outer arm backwards. The lop the tip off with wire cutters. Now it fits in there snug and perfect and the screw moves the steering linkage perfectly.

Before I place my order for the motor and wait 2 months. What am I going to use for a pinion gear that will work with the stock spur gear? Is it available from hobbyking? I am going to put an order there soon.
shahram72 is offline Find More Posts by shahram72
Last edited by shahram72; Feb 05, 2013 at 09:55 PM.
Reply With Quote