Thread: Discussion Andy Sheber Pitts s1s
View Single Post
Old Feb 05, 2013, 06:01 PM
ace4rc is offline
Find More Posts by ace4rc
Registered User
ace4rc's Avatar
tampa,florida
Joined Nov 2007
2,359 Posts
Well, I'll be a soamfsob!
Got the top wing on the board and commenced to measureing off of the plans. Made all the mark's and thought hmmmmm this looks different than the bottom. So I went and re-measured the bottom. I am a retard. Apparently when I did the bottom I made the first cut and continued to build from it instead of makeing the other cuts as marked. I guess after cutting the aileron off I must have turned everything over and commenced to build from that cut. I ended up with an aileron 1/2" smaller than it is supposed to be.
The first pic is where the pivot, hinge point, is suppose to be. The second pic displays the three marks (of which I did not use) the top mark is the wing T/E, bottom mark is the aileron L/E, and the middle mark is the pivot point or suppose to be.
So I get to build them again!
ace4rc is offline Find More Posts by ace4rc
Reply With Quote