Thread: Discussion Andy Sheber Pitts s1s
View Single Post
Old Feb 05, 2013, 09:49 AM
ace4rc is online now
Find More Posts by ace4rc
Registered User
ace4rc's Avatar
tampa,florida
Joined Nov 2007
2,359 Posts
How I do it. I cut a strip of 1/16 ply, then measure and mark up for the screw holes and drill them out. In this case the screws are 1" apart with the first one on the strip at 1/4 from the end. Thats how they measure out from the plans. Then I tape the strip in place, triple check. Then drill the holes.
I started on the Pitts with #0-3/8 but the head size just looked to small to me. So I went with a #2 screw, it is a little larger than scale but looks better to me.
ace4rc is online now Find More Posts by ace4rc
Reply With Quote