View Single Post
Old Feb 05, 2013, 03:17 AM
x_rui is offline
Find More Posts by x_rui
aka icsss
Joined Feb 2012
145 Posts
Quote:
Originally Posted by Paku View Post
You should have the power on the ESC 3pin connectors (motors).
Use std. serwo cable to grab a power from that place - prepare a special cable.

or (I do it like that):

Remove a signal pin from your servos plug /usually yellow or white cable/. Connect it to the required slot on the board (d33, d32) while connecting remaining 2 (servo power) using original plug to the unused ESC ports.
I'm using pins 44 and 45 for gimbal servos (FC=AIO PRO), signal and power wires.
Are you saying that I should take the signal from 33 and 32 and power from unused esc pins?

Thanks.
x_rui is offline Find More Posts by x_rui
Reply With Quote