Thread: New Product Parkzone's VisionAire
View Single Post
Old Feb 04, 2013, 11:29 PM
d2tw4all is offline
Find More Posts by d2tw4all
Registered User
United States, RI, Smithfield
Joined Dec 2011
779 Posts
Quote:
Originally Posted by SLK Count View Post
nice flight Zmonster, hope the sky will be blue here next time.
Did you fly with higher rates in 3D mode or are there still 70% D/R ?
-
Did anybody check the Turnigy 2200mAh packs ? How do you feel with it ?
I soldered my ESC yesterday and now I have XT60- the advice to remove the ESC out of the fuse was a good tip-otherwise it would be a hard challenge to solder into the fuse.
Will also mod my other clevis at rudder and aile with steel pins next time..weather is bad and therefore I will spend my time for recommended mods.
Ya it's a pretty easy job to remove the ESC and you can then solder with no risk to melting foam or doing a bad solder job because of limited access... Glad it worked out for you. Hoping to get this bird in the air again tomorrow as there is no wind forecast...but snow. Might just have to fly in the snow!

Tom
d2tw4all is offline Find More Posts by d2tw4all
Reply With Quote