Thread: Discussion TechOne Owners Thread
View Single Post
Old Feb 04, 2013, 03:19 PM
wolfewinde is offline
Find More Posts by wolfewinde
My Co-Pilots Rock!!
wolfewinde's Avatar
United States, FL, Clearwater
Joined May 2011
1,665 Posts
Actually, I have a DX8 so I can program 3 sets of rates/expo. On most planes I set up as follows to start..

low rate = 70% throw/25% expo
mid rate = 90% throw/35% expo
high rate = 110% throw/45% expo

exeptions are these....

3D plane - 50% throw low rate to start
elevator - I also set it just below "snap" on low and mid rates

I don't change end points unless I want to go past the 110% throw - then I mess with end points.

My max set up on a 3d plane is 150% throw and 75% expo. I have to really be in the mood for that and don't so it often since I m not a very skilled 3D pilot at this point

Another exception is that I will often back down on the rudder settings with a lot less expo so I don't have to move the throttle/rudder stick so far to get lots of rudder. Depends on the plane and how I want to fly her. I still have a lot of trouble keeping constant throttle if I have to move the rudder stick too far.

Wolfe
wolfewinde is offline Find More Posts by wolfewinde
Reply With Quote