in the case of the albatross: (again, assuming you want Mode2 which is standard in the US)
plug the rudder servo into channel 1 on the receiver,
plug the ESC plug into channel 3 on the receiver.
plug the elevator servo into channel 2 on the receiver.
you'll end up with the rudder and elevator controls on the right stick, and only the throttle on the left stick.
- Channel 1: Aileron
- Channel 2: Elevator
- Channel 3: Throttle
- Channel 4: Rudder
- Channel 5: Train returning (Gear).
- Channel 6: Shutters (Flaps).
- Channel 7: Auxiliary 1 and fins 2 (for differential).
- Channel 8: Auxiliary 2.
- Channel 9: Battery.
hope that helps!