View Single Post
Old Feb 04, 2013, 10:25 AM
BThirsk is offline
Find More Posts by BThirsk
Brent 黑雁
BThirsk's Avatar
Canada, AB, Ponoka
Joined Jan 2012
1,801 Posts
Quote:
Originally Posted by SmokeNGun View Post
Okay I think I follow what your saying, I have remove the power lead from the esc servo lead then that gets plug into the gyro. The orange signal wire of the gyro plug into the clear channel on the orangerx RX and the other plug with three wires going into the rudder channel with the power lead being disconnected. What happen is that the tail esc all it does is beep. Seem that it not getting a signal to the signal wire. If I plug the tail into the rudder channel it works but that not what I'm trying to do here. Do I need to unbind the tail esc if that can be done and start over ? Or are you saying I need to power up the tail esc after the main esc and rx tx are bond ? But there again where is the tail esc getting its signal from to activate.
This a hole project has been driving me up the wall.
Read this. It is detailed information on what I did.
http://www.rcgroups.com/forums/showp...9&postcount=12
The issue you are having is the Tail Esc cannot be powered up the same time as the main ESC which power the RX. You power up the RX/Main ESC first and then when you are powering up the Tail ESC, the Rudder port has signal and the Gyro is inititialized.
BThirsk is offline Find More Posts by BThirsk
Last edited by BThirsk; Feb 04, 2013 at 10:42 AM.
Reply With Quote