View Single Post
Old Feb 03, 2013, 04:34 AM
Paul@SCC is offline
Find More Posts by Paul@SCC
Registered User
Chalfont St Giles, Bucks, UK
Joined Jan 2007
3,221 Posts
Originally Posted by caotri View Post
Real cool Paul.
Any more information about cost and cameras supported.
Thanks for very nice design shared.

Thanks CaoTri.
Cameras supported.
The tilt cage was measured to accommodate a 7d, but we will have to make the cross slide mech a little slimmer. So any camera up to that size really.
The sliding mechs have enough travel to balance from a Point and shoot to the DSLR size of camera.

About the cost of this gimbal.
Until we have all three axis in the air and perfectly stabilised it is worth nothing.

Originally Posted by jeju View Post
I envy your ability.
Well done you are admirable.
Hi jeju. Thanks for your kind words. I will pass them on to my mate.
Paul@SCC is offline Find More Posts by Paul@SCC
Reply With Quote