Thread: Rave Futaba T8J S-FHSS
View Single Post
Old Feb 02, 2013, 10:33 PM
Phroso is offline
Find More Posts by Phroso
Registered User
United States, GA, Norcross
Joined Dec 2012
21 Posts
Quote:
Originally Posted by numnutchris View Post
The 8J is the first Futaba Ive seen in which you dont have to REVerse THR for ESCs. Use an empty (or resetted) model memory and watch the servo screen and youll see the THR going the opposite way than the other stick.
So, TX on, full throttle, RX on, some short beep (assuming you have ESC wired to a motor - without prop), pull down throttle and youre done. If youre using a flight controller you need to check its manual.
You might want to look at the THR.CUT and change its MODE to ESC and MIX to OFF (not INH), move down to THR, set stick to min and press the jog for 0%. Enable any switch & position as safety switch.
NOTE: If you hit the switch you have to pull down THR stick before enabling it by the switch, check the SERVO monitor again.
Thanks, I tried this before (slightly different method) and yours as well, didn't work. TX beeps constantly if throttle stick is all the way up, warning I guess that throttle is 100%!?
Phroso is offline Find More Posts by Phroso
Reply With Quote