View Single Post
Old Feb 02, 2013, 05:07 PM
Tahoe Ed is online now
Find More Posts by Tahoe Ed
DJI Support
Las Vegas/Lake Tahoe
Joined Feb 2010
14,058 Posts
The point RT was trying to make is if the copter is not balanced well or the arms are slightly tweaked then it will show up in Manual. The controller will mask a lot of these ills until a motor burns out or an esc connector fails and the owner goes, it just quit! Well the root cause was probably a poor mechanical set up. RT takes his time and balances everything, so do I. I have very few problems because of that. Try it some time it works well. When was the last time you checked all the motors when you landed and were they all the same temp. If not you have a problem.
Tahoe Ed is online now Find More Posts by Tahoe Ed
Site Sponsor