View Single Post
Old Feb 02, 2013, 04:11 PM
olllian is offline
Find More Posts by olllian
olllian
olllian's Avatar
United States, AZ, Chandler
Joined Nov 2011
608 Posts
Quote:
Originally Posted by jstoll View Post
hey olllian I got my watt meter and the 7X8 with the timing set at 30* watts are at about 400
7X6 prop at 15* was just over 300 and the 7X8 at 15* was about 350 the RPM is higher with the timing at 30*. I dont think the over square prop will unload that well unless in a dive, I was thinking about putting on the 8X8 and pulling the timing back to 7* Id bet that would be about 700 watts ... I wonder what the stock motor is capable of before it starts to make heat and effeciency falls off .... when I was doing motor R&D I did many 25KW pulls and watched as heat increased how effeciency would fall off. I did get my prop drive 35/36 1800 today ... did you have a plate that will bolt this to the stock mount?
take care
JAK
edit



the battery on the tests above was a little low Ill repost over the weekend corrected numbers ... I thought they were a little low.
did a pull with the 7X8 on a fully charged battery 2200 45-90C 4S and got about 560 watts at 30*.... so it might be safe to add 150 watts to the above numbers



the rare bear on a 1000 25-50c 4S pulled just under 300 watts with a 5.1X4.5 spoonie prop
JAK
I am not sure what bolt pattern u have on that motor.
olllian is offline Find More Posts by olllian
Reply With Quote