Thread: Discussion V912 Motor options
View Single Post
Old Feb 02, 2013, 03:41 PM
Balr14 is offline
Find More Posts by Balr14
Cranky old fart
Balr14's Avatar
Germantown, WI.
Joined Oct 2007
21,560 Posts
Take a scissors and cut about 1/8" (for starters) off the entire length of the trailing edge of the blade. It will decrease lift and resistance and make the motor run at higher rpms. Otherwise, they can bog and draw too much current and toast the FET on your board. But, I don't know how the Xtreme 380 runs on 7.4v . Try it first. You may not need to trim the blades.
Balr14 is offline Find More Posts by Balr14
Reply With Quote