View Single Post
Old Feb 02, 2013, 03:27 PM
Helitime is offline
Find More Posts by Helitime
Registered User
Pickering Ontario CANADA
Joined May 2010
842 Posts
Quote:
Originally Posted by Saschi View Post
Hi,

connected two spektrum (orange R100) sats to G31. What about FAILSAFE?
Can anyone say something about this important thing?

Saschi
Hi Saschi
First post! Welcome to RCG.


Disconnect the wires to the motor before doing this!!!
In case you are not aware. To set fail safes set all your transmitter controls (sticks and switch's) to where you want them to fail to ie: throt. off, centre ail, ele and rud. etc. Then bind or rebind the receiver to the transmitter. As a test you can hold sticks off centre and shut off the Tx. The servos should move to your preset "fail safe" positions.
Hope this helps
Kerry

This is the method for Spektrum gear, not sure about the rest. "Orange RX" receivers usually say "with fail safe" if they have it.
Helitime is offline Find More Posts by Helitime
Last edited by Helitime; Feb 02, 2013 at 03:43 PM.
Reply With Quote