View Single Post
Old Feb 01, 2013, 11:57 PM
Gene is offline
Find More Posts by Gene
Registered User
United States, CA, Anaheim
Joined Aug 1999
1,367 Posts
Discussion
Multi motor programming Joe or Bernie ?

I recall reading an article by Joe Ford a few years back on how to set up two Phoenix ESC's to control two motors. There were certain settings that you would program the two controllers to and these settings would apply to both ESC's. I printed the information out, but of course, I can't find it now. I'm programming two Phoenix 35's to power two motors on a B-25. Joe, could you direct me to where that article is on your Castle Creations site or would you list those settings here, so that I can proceed with this project. Thank you.
Gene is offline Find More Posts by Gene
Last edited by Gene; Feb 02, 2013 at 12:14 AM. Reason: Spelling error
Reply With Quote