Thread: Discussion Ecureuil AS355N
View Single Post
Old Feb 01, 2013, 07:56 PM
SRWitt is online now
Find More Posts by SRWitt
Registered User
Joined Jan 2011
112 Posts
Well it may not be exact to the 3 view, but who says thats "scale". I've got the main body of the fuse looking pretty good, nice transitions, no real edges to it, just a nice surface. Time to start the easy part of adding the smaller details, the rest of the windows, the engine cowling and tail rotor drive shaft tunnel/gear box. Total time so far 5-6 hours just to get it to this point. The detailing goes pretty quickly, throw in some lines to approximate the shapes, extrude/trim my surfaces and tweak the line drawings until they look right. No real compound curves in the details so that speeds things up tremendously.
SRWitt is online now Find More Posts by SRWitt
Reply With Quote