View Single Post
Old Feb 01, 2013, 07:27 PM
jhiggy is offline
Find More Posts by jhiggy
Registered User
United States, OR, Tigard
Joined Dec 2012
90 Posts
Quote:
Originally Posted by dz1sfb View Post
If you are looking for a way to edge glue two sheets together, I can recommend the method we'd use for balsa sheets, by trimming the long edge of two sheets stacked together with a straight edge, Make one square cut through both sheets against the straight edge. Now flip the top sheet over as though hinging on the cut edge. Next pull the cut edges tight together taping the joint facing you. Now you can hinge open the gap for adhesive, then lay closed again. If you use Gorilla Glue use a small bead, flatten back out then tape the open side of the seam closed. This will yield a strong expansion free joint that requires little if any subsequent attention. With any of the contact like glues such as FoamTac do not tape the open side of the joint once the glue is in, or you may get some foam melting if there is no place for the adhesive to outgas.

Hope this helps,
Ken
Thanks!!!
jhiggy is offline Find More Posts by jhiggy
Reply With Quote