Thread: Build Log Pike Precision - Baudis RDS
View Single Post
Old Feb 01, 2013, 06:00 PM
Dyno Don is offline
Find More Posts by Dyno Don
Registered User
Dyno Don's Avatar
USA, CA, Vista
Joined Jun 2003
243 Posts
Loctite

Quote:
Originally Posted by tewatson View Post
Yeah, the clear templates are the shizzle. Even a little off with the servo angle from one side to another can cause wack flap deployment. That is what's so nice about RDS...match all the install stuff up and the surfaces move evenly, both sides, on the first try.

Tom
Quote:
Originally Posted by ttraver View Post
Hey Don,

I don't know about that one. It would probably be ok. You need to look up how well loctite does with metal on metal. I know JB Weld does good, so that's why I went with it. I'm sure anything that makes a tight bond with metal will do.

t
I was thinking of the Red 262 Thread locker. Should be fine..
thanks Tim,, again great job on your write up!!
Dyno
Dyno Don is offline Find More Posts by Dyno Don
Reply With Quote