View Single Post
Old Feb 01, 2013, 12:31 PM
johnyeros is offline
Find More Posts by johnyeros
Registered User
Joined Jan 2013
25 Posts
Quote:
Originally Posted by Firehawk989 View Post

For the coupler you could try this:
http://www.ebay.com/itm/DR-3mm-x-3mm...item1c2819b3f0

or this:
http://www.ebay.com/itm/BF-3mm-x-3mm...item19d239a7a6

and get a piece of 1/8in OD brass tubing which conveniently has an ID that is the same as the impeller shaft for the NQD. Drill a hole in it for the set screw, stuff in your coupler, and you're good to go!
Remember I told you guys i bought this before we realize it's too big. Anyway.. It arrive from china today. This thing is the side of my thumb..
Even if i get the adapter to work correct.. Is this coupler too big for the motor setup and the shaft?
johnyeros is offline Find More Posts by johnyeros
Reply With Quote