View Single Post
Old Feb 01, 2013, 09:56 AM
Dan5.0 is offline
Find More Posts by Dan5.0
RC Toys R 4 White Trash
Dan5.0's Avatar
Joined Dec 2008
4,089 Posts
Guys I wanted to share a little build trick we've been toying with in order to keep from gluing your servos in permanently, and this works outstanding.

For servo installation simply run a bead around the servo and let cure. As for the servo slot just smear Welders into the foam it you don't want a bead of Welders in there. This is easily an over night cure on the glue too. If the glue is at all tacky it will be in there like concrete. If done correctly the two Welders surfaces create a rubbery hold that keeps the servo from moving but makes removing them very easy...
Dan5.0 is offline Find More Posts by Dan5.0
Last edited by Dan5.0; Feb 26, 2013 at 02:45 PM.
Reply With Quote