View Single Post
Old Feb 01, 2013, 01:05 AM
digitalCAM is offline
Find More Posts by digitalCAM
United States, WA, Mason
Joined Apr 2011
1,079 Posts
Originally Posted by GGoodrum View Post
Attached is the new LG/IMS setup for the F330. This setup will now have three distinct levels of isolation, rubber grommets on the motor mounts, some of John's speargun tubing between the F330 lower plate and the LG center section, and then finally the regular IMS silicon isolators which are spaced wide apart. Initially, this will get a simple plate, that will be attached to the H3B's plastic housing, but eventually I'll add the new compact tilt-only gimbal that Andrey is finishing up.

-- Gary
Hey Gary, glad to see you're still getting to put some of my rubber washers to experimental use. -- Looking forward to the tube baseplate going up on your site. Using its, are you able to get your RX100 balanced, and still have the lens close to the axis pivot point? -- Don't want to get a controversy going over whether that is necessary or not. I just want to put it there, cause I want to put it there. -- JOHN
digitalCAM is offline Find More Posts by digitalCAM