Thread: New Product The FPV Raptor Thread
View Single Post
Old Jan 31, 2013, 10:09 PM
urbansniper is offline
Find More Posts by urbansniper
Registered User
United States, TX, Houston
Joined Nov 2012
342 Posts
Quote:
Originally Posted by Euwan View Post
OK so I have installed the 28-36 1800kv motor with 8x4 prop, I have an 50amp ESC. Just need to make sure that this combination is fine ? Also I have noticed that the motor wobbles inside the housing is there any way to reinforce it?
Quote:
Originally Posted by blueprint View Post
I have the same setup except im using a 60a esc. My motor does not wobble though. Did you tighten the screws in? Perhaps the prop is not balanced. Im using an apc 8x6 prop.
hello; does the plane hand launch well with the NTM 28-36 1800KV motor?

I have the following nanotech lipo's I would like to try an use with this project:
- 2200 4S 45C
- 2650 3S 35C
- 2200 3S 25C
urbansniper is offline Find More Posts by urbansniper
Last edited by urbansniper; Jan 31, 2013 at 10:23 PM.
Reply With Quote