View Single Post
Old Jan 31, 2013, 06:45 PM
isaacintheclouds is offline
Find More Posts by isaacintheclouds
Support yer local CharlieSheen
isaacintheclouds's Avatar
United States, CA, Carnelian Bay
Joined May 2011
1,400 Posts
Oops

Wonderful. Just when I think I have my roll jitter figured out on my Ag550 after finding that the roll pulley was a little tight on the shaft and backing that off a bit so it wouldnt bind, updating the hfg to 1.9 and re-re-re-calibrating everything, I accidentally plugged my servos in one pin off to the right and it appears to have fried them both. Before I get 2 new ones has anyone used any other servos that performed any better than the MKS? @#%$@$^@$$%^@!!!!!!!!!
isaacintheclouds is offline Find More Posts by isaacintheclouds