Thread: Build Log Ezb
View Single Post
Old Jan 31, 2013, 06:41 PM
derk is offline
Find More Posts by derk
derk's Avatar
USA, ID, Coeur D'Alene
Joined Dec 2003
5,610 Posts
ok thanks for the tips, seems i was a little off on what sizes i did order. i got .050, .040, and .030
so still a decent range for this type of plane, maybe a bit larger for the next one
as for the winder, i was thinking of opening it up and moving the pinion to the next gear out as it would increase the speed but will still count as the counter is on the output not the idler shaft. i will see if it still runs good that way and use it only for smaller rubber sizes. i just really like having a powered winder and counter in one. maybe i need to build a super charged brushless winder
derk is offline Find More Posts by derk
Reply With Quote