Thread: Discussion ESC brushless 60amp wires
View Single Post
Old Jan 31, 2013, 04:32 PM
imgumby is offline
Find More Posts by imgumby
Registered User
imgumby's Avatar
United States, CA, Pinole
Joined Jan 2009
1,011 Posts
Quote:
Originally Posted by sliderguy View Post
I have terminates on the brush-less motor. Its just the case of soldering the 3 wires per terminal. Would i need to heat shrink each terminal?
Heat shrink at the motor terminals really isn't needed since they're static but couldn't hurt.Insulating any loose connector ends is a must however.

hope this helps
imgumby
imgumby is offline Find More Posts by imgumby
Reply With Quote