View Single Post
Old Jan 31, 2013, 04:14 PM
19000rpm is offline
Find More Posts by 19000rpm
Registered User
Joined Aug 2009
3,021 Posts
Quote:
Originally Posted by kryznic View Post
Thanks Mike! I have to order some rubber bands so might as well buy a 2 dollar shaft to be safe.

I have one more question if anyone has any knowledge on this. On my radio my trims are adjusted almost to the max for elevator and rudder. How or what do I need to adjust on my plane so that I can get those trims as close to center as possible?

Oh and if anyone has any good reading on the effects of prop size on the draw of the motor/battery I would love to see it.

Thanks!
First, make sure your servo arms are centered or near center on the servo. If they are not remove and place them centered. After powering up to confirm centering, adjust the plastic clevises on the end of the control rod (turn left or right) until they are the right length, when installed on the control horn, where the elevator and rudder are in line with the stabilizer they are hinged to.
19000rpm is offline Find More Posts by 19000rpm
Reply With Quote