View Single Post
Old Jul 16, 2004, 07:43 PM
Bernoulli~Bros is offline
Find More Posts by Bernoulli~Bros
Gettin' Lifted
Bernoulli~Bros's Avatar
Hole In The Earth, CA
Joined Feb 2004
322 Posts
It has arrived!!!

As usual I wasted no time getting started....

Wing halves glued together w/ shoo goo in the center, and 5 minute epoxy around the gaps/edge's.

A mistake was made, and my kit was shipped without the spar slot pre-cut But thanks to the help of Justins wife(Justin is out of town), and a member here , I got the correct measurments and cut the slot myself, beings this is my first time working with EPP, turned into kind of a butcher job, but it worked out ok, I think(does it look about right?) .

I hope I can do better cutting this stuff when I cut out my servo bays any suggestions for clean cutting EPP without a dremel??

Jay
Bernoulli~Bros is offline Find More Posts by Bernoulli~Bros
Reply With Quote