View Single Post
Old Jan 30, 2013, 04:08 PM
bz1mcr is offline
Find More Posts by bz1mcr
AKA Don
bz1mcr's Avatar
United States, MI, Houghton Lake
Joined Dec 2002
7,746 Posts
Quote:
Originally Posted by Jwmflying14 View Post
http://www.rcgroups.com/forums/showt...hp?t=1820026ys, this foam is amazing.

Once again I am here just amazed with this product! This airframe is currently 75% constructed. I have cut through an entire sheet so far with only one blade! How is that even possible?! I was used to depron and a new blade every 2-4 cuts.

At on point I decided to mix in some of my left over depron. This I will never try to do again! That stuff is crap! After getting used to working with MPF depron is just so fragile. It doesn't bend or cut as nicely. MPF seems to slice like butter. I have yet to have a "tear" or less than reasonably clean cut.

It is slightly less stiff, however not nearly enough to worry about.

Check out my build (link at the top). Be nice, its my first build in over a year.
Thanks for the kind words about MPF. I think, this is the first comment about cutting blades staying sharp longer. Frankly I had not noticed that. What do the rest of you think? Is this another advantage for MPF?
bz1mcr is offline Find More Posts by bz1mcr
Reply With Quote