Thread: Discussion Futaba 8FG(S)
View Single Post
Old Jan 30, 2013, 01:24 PM
Skaluf is offline
Find More Posts by Skaluf
Skaluf's Avatar
Sadorus, IL
Joined Mar 2004
597 Posts
If you are talking about linking two R7008SB receivers, with one of them outputting chans 9-16, you can use any normal device you want on those PWM outputs. S.Bus servos plug into the S.Bus port. The numbered outputs are normal outputs as long as you have the receiver in the correct mode.

Here is a short video on linking two receivers to the 18MZ (same process as the 14SG).

Linking two R7008SB Receivers to the 18MZ (4 min 46 sec)


Steve

Quote:
Originally Posted by MCrites View Post
Ok so I finally got around to this project. I read the manual and from what I understand now after some testing is I can only use the conventional 1-8 ports as 9-16 if I use a compatible SBUS servo. I was wanting to use the conventional 1-8 ports as 9-16 for things like my camera switcher, or LEDs, or gimbal tilt control (via a gimbal controller. Is this possible? Is there a way to tell the Rx "hey, your ports 1-8 are all 9-16 now...". I see how it is possible for SBUS servos but not for my regular equipment.
Skaluf is offline Find More Posts by Skaluf
Site Sponsor
Reply With Quote