Ok I tested out the new settings today, but there is no AS3X anymore
Everything else works fine though.
Arrrrrggggggggghhhhhhhhhh!!!!!!!!!! īThis is a nightmare
Are there any tips for this scenario?
Also whenever I open a model setup I get this error message (the number varies depending on which setup I choose):
Is this error normal?
EDIT: I got my AS3X to function again. Because Im in germany on a german computer the region was set to germany, duh! In the german numerical system they use ',' instead of '.', this somehow corrupted the model config files, so I had to change the region to Australia where full stops are full stops and commas are commas. After reprogramming it under the australian region the AS3X now works again.
This is actually handy to know if you want to turn the AS3X off. I have seen many people ask if you can turn it off to which the answers were a resounding NO!
BUT.... If you change your region to Germany (Control panel / region and language) and attempt to program your receiver it will remove the AS3X functionality. Then to restore it you simply change your region back to where you actually come from and reprogram it again.