Thread: Discussion Curtiss flying boat
View Single Post
Old Jan 30, 2013, 10:29 AM
series57r is offline
Find More Posts by series57r
Registered User
United States, LA, New Orleans
Joined Dec 2012
115 Posts
Thanks minimicrorc

Enlarged a 3 view to 14 inch span and looking at that if I raise the prop shaft then
cut 1/4 inch or less off the blade tips of propeller that I would have about 1/8th inch clearance.
Would the reduced load on the motor be a problem?
Not much on electric motors, back in the day everything was glow engines.


Now I need to figure out what exactly Depron is.
As well as finding a good source in the States.
If Depron is what the elevator and rudder of the Sukoi are made from this appears to be the same a pick nick plates? Playing around it looks like foam super glue works well.

Learning is fun and have I got allot to learn about this 'new' stuff.
series57r is offline Find More Posts by series57r
Reply With Quote