Thread: Discussion Capacity Testing XPS
View Single Post
Old Jan 29, 2013, 03:15 PM
E_ferret is offline
Find More Posts by E_ferret
Registered User
E_ferret's Avatar
Launceston Arpt, Tasmania, Australia
Joined Jan 2004
564 Posts
Quote:
Originally Posted by ezflyr View Post
Hi All,

I have a pair of 2S, 2300 mAH A123 packs I purchased from XPS about a year ago. At the time I fully charged them with a Thunder Power balancing charger. I'm about to use these packs now, so I'd like to capacity check them first. When I attempt this, I end up with a ridiculously low capacity of 75 mAH or something like that. When I recharge the packs, that is approximately the same amount being put back in. I assume I'm not discharging them properly, and probably ending prematurely. What is the per cell cutoff voltage that is appropriate to these A123 batteries?

Anything else I might be missing?

Thanks,

John
You can use your computer for more than communicating with Jim!
required information is only one click away;
http://www.a123systems.com/Collatera...ta%20Sheet.pdf
E_ferret is offline Find More Posts by E_ferret
Reply With Quote