Thread: Build Log Plank 1mp
View Single Post
Old Jan 29, 2013, 11:29 AM
Jon Snow is offline
Find More Posts by Jon Snow
You know nothing....
Jon Snow's Avatar
Joined Sep 2011
3,626 Posts
Full span 12k carbon on the spar line.It didn't show much on the previous pics,but I'd managed to get the grooves a couple of mm out of line at the centre,which is a bummer.So set to work and did a bit of blending with the spar cutter,hence the slight curve.I also had to clean the groove in a few places where epoxy had pooled.
After all that the tows went in well,best effort so far.
The fin also got some tow either side of the front edge.I'm hoping the whole shebang will end up a touch nose heavy so I can do Marks foam infill and glass- or maybe infill and tissue.
Jon Snow is offline Find More Posts by Jon Snow
Reply With Quote