Thread: Mini-HowTo VTOL-Trainer Build Thread
View Single Post
Old Jan 28, 2013, 02:05 PM
Ran D. St. Clair is offline
Find More Posts by Ran D. St. Clair
Registered User
Ran D. St. Clair's Avatar
United States, CA, Sunnyvale
Joined Dec 2006
1,814 Posts
Quote:
Originally Posted by nadine View Post
Hi guys,
sorry if i ask...
What could possibile hapened if ,somehow with the help of electronic switch,to disconnect the pin from the kkv1 -168ap board,after hovering or even in line with servo slower,at the 3 gyro on the board!?It will be throtlle controll at the motors?
I'ts a stupid question!?
I am using a KK2 not a KK1 so I can't answer your question. I am not sure what pin you are suggesting to disconnect. If you are suggesting to disconnect the pitch, roll, and yaw input from the receiver, then it might default to throttle only. Even if the pitch, roll, and yaw inputs default to neutral, I assume the stability feedback would still be active, so it would not be entirely throttle only. I suppose you could just unplug those inputs and find out. If it works then a hardware solution is always possible. The more modern solution would be to modify the code of the flight controller board. There is nothing wrong with creative thinking though.
Ran D. St. Clair is offline Find More Posts by Ran D. St. Clair
Reply With Quote