Thread: Discussion FY DOS autopilot
View Single Post
Old Jan 28, 2013, 11:50 AM
Ineedmoreparts is offline
Find More Posts by Ineedmoreparts
Registered User
Joined Jan 2012
16 Posts
I'm going to go out a limb and state that I thought RUD nav was more for 3D operation in 3D mode. With other stablization systems there is no need to change channel assignments. So if I have ailerons and rudder, does the channel assignment stay the same(ail Channel 1, Rudder channel 4? If a wanted to do a knike edge in 3d mode, wouldnt I chose Normal setup with Rudder Nav? That just a question, I cant do knife edges?!?!?!?!?!?!!!??

In other words can you do 3D flight if you chose 1. Normal vs 4. Normal(rud NAV)?

After serveral attempts my emails to feiyu have finally gotten thru their spam filter.
Ineedmoreparts is offline Find More Posts by Ineedmoreparts
Reply With Quote