View Single Post
Old Jan 28, 2013, 05:22 AM
Isoprop is offline
Find More Posts by Isoprop
Registered User
Joined Nov 2010
2,865 Posts
Quote:
Originally Posted by e_lm_70 View Post
RS232 solder points ... ???

Do you have a picture of these points ... I would be curious to see what it show on serial port

Like I said, I haven't tried this on the new design. On the original #11 the points were situated at the edge of the board next to the processor. On the new design there are three points, instead of four, next to the processor. These look suspicious and could well be TX, RX and GND. If you have a TTL to RS232 converter you could try hooking up the TX (I'm sure it's one of them) and a ground point.
Isoprop is offline Find More Posts by Isoprop
Last edited by Isoprop; Jan 28, 2013 at 06:34 AM.