Thread: Discussion Hitec Aurora 9 Transmitter
View Single Post
Old Jan 27, 2013, 10:39 PM
Craig Downer is offline
Find More Posts by Craig Downer
Suspended Account
Joined Mar 2012
99 Posts
Quote:
Originally Posted by gvdl1 View Post
Ok it would seem I'm a total NOOB here. All new firmware, installed in glider and everything working fine. Started trying out different mixes and all working. Did Camber mix with a switch and a slider no problem. Then I went back later to set Camber and nothing, won't work on a switch or a slider. Now I can get Landing to work but not Camber or Launch. I went through everything and I have no other active mixes. Earlier I did set flight conditions but I have since deleted them all. Tried rebinding no change. I'm finding this really weird.
I pretty sure I'm just missing most likely some small thing but beats me as to what it is. Any ideas out there?
I would delete the model and start over. You will save yourself a lot of time if you haven't already.
Craig Downer is offline Find More Posts by Craig Downer
Reply With Quote  (Disabled)