Thread: Discussion Hitec Aurora 9 Transmitter
View Single Post
Old Jan 27, 2013, 10:34 PM
Highfly! is offline
Find More Posts by Highfly!
Registered User
Highfly!'s Avatar
United States, CA, Cameron Park
Joined May 2007
1,261 Posts
From experience the best you can do is just reset all and start fresh. Setup your flight modes first and decide what you want to do in each mode. I had similar behavior in the past and figured that starting from scratch goes faster than trying to figure everything out.

Quote:
Originally Posted by gvdl1 View Post
Ok it would seem I'm a total NOOB here. All new firmware, installed in glider and everything working fine. Started trying out different mixes and all working. Did Camber mix with a switch and a slider no problem. Then I went back later to set Camber and nothing, won't work on a switch or a slider. Now I can get Landing to work but not Camber or Launch. I went through everything and I have no other active mixes. Earlier I did set flight conditions but I have since deleted them all. Tried rebinding no change. I'm finding this really weird.
I pretty sure I'm just missing most likely some small thing but beats me as to what it is. Any ideas out there?
Highfly! is offline Find More Posts by Highfly!
Site Sponsor
Reply With Quote