Thread: Discussion QTR Quad Tilt Rotor
View Single Post
Old Jan 27, 2013, 10:20 PM
RCvertt is offline
Find More Posts by RCvertt
Registered User
RCvertt's Avatar
Joined Aug 2007
4,536 Posts
Quote:
Originally Posted by tom-tom 1 View Post
I went to the field today ready for forward flight. I had problems with my board. It just didn't act right. The motors didn't run up correctly. The variable thrust didn't work and the motors didn't smoothly power up. They came to half speed and then suddenly full power without my increasing the throttle. I couldn't see anything wrong but the other day a wire came loose from the board. I think I need to glue the wires to the board to take the strain off the solder joints.
If you make a code change and it doesn't act right afterwards, don't try to fix that file by trying to undue your changes. Start with a fresh file that you know works and that you haven't made any changes to, then try to make your changes again. Always start with a fresh file until your changes work.
RCvertt is offline Find More Posts by RCvertt
Reply With Quote