Thread: Discussion Another new 2.4GHz system!
View Single Post
Old Jan 27, 2013, 02:38 PM
gulio is offline
Find More Posts by gulio
That's a funny word
NE Ohio
Joined Apr 2003
3,696 Posts
I had to remove the module form the Turnigy 9x and I now need to re-install it. Is this just a single wire that I can simply solder back onto the board once I get the wire pulled thru the case again?

I can't quite see good enough to make it out. I had no trouble removing it, I think I just cut it at the solder point on the board.
gulio is offline Find More Posts by gulio
Reply With Quote